Micro-Armor 1000 Engine and Oil Treatment

Oil Additive and Lubrication Product Data Sheet - Micro-Armor 1000 PDF file
BTS Test Report - Compression Test - Camry PDF file
micro-armor 1000

Micro Armor 1000 Product Description

Micro-Armor 1000 is a unique lubricant additive designed to enhance the performance of petroleum-based and synthetic lubricants far beyond virtually any known competitor today. The Micro-Armor 1000 uses a proprietary blend of patented micro-particle additives that impart extraordinary properties for lubrication and equipment maintenance. The special lubricant additives allow for a reduction in friction, heat, wear, and energy consumption in areas where maximum lubrication and protection is desired. The end result is that Micro-Armor 1000 protects your equipment, and investment, from expensive downtime and excessive maintenance.

Benefits

  • Reduces Friction
  • Increases compression and horsepower
  • Reduces operating temperatures
  • Reduces gear chatter
  • Reduces wear on all metal components
  • Dramatically extends equipment life-cycle
  • Reduces Exhaust Emissions

Recommended Application Areas

  • Gas or Diesel Combustion Engines
  • Gear Boxes
  • Pumps
  • Manual Transmissions
  • Hydraulic Systems
  • Differentials
  • Transfer Cases
  • Power Steering
  • Air Compressors
  • Turbines
  • Wet Bearing Wheel
  • Sliding Bearings

Technical Information

  • Appearance and Odor    =   Slightly oily odor
  • Specific Gravity (Water = 1)    =   1.05
  • Solubility in Water    =   Less than 0.1%
  • Pour Point    =   -10 degrees F (Pennzoil motor oil and Micro-Armor 1000)
  • Boiling Point    =   550 degrees F
  • Vapor Pressure    =   Less than 0.1mm Hg @ 20 degrees C
  • Vapor Density (Air = 1)    =   Greater than 5
  • Flash Point (Cleveland Open Cup)   =   465 degrees F minimum
  • Load Wear Index ASTM D-2783-81    =   48.27 Kg (Pennzoil motor oil and Micro-Armor 1000)
  • Weld Point ASTM D-2783    =   315 Kg (Pennzoil motor oil and Micro-Armor 1000)

Treatment Ratios

Gas and Diesel Engines:
Add 1 oz. of Micro-Armor 1000 per quart of oil up to 16 quarts and 1/2 oz. per quart thereafter.

In New or Rebuilt Engines:
Allow manufacturer's break-in period to elapse before adding Micro-Armor 1000.

Future Oil Changes:
Continue the recommended oil change schedule adding the proper dosage of Micro-Armor 1000 with each oil change.

Standard Transmissions, Differentials, and Gear Boxes:
Add 4 oz. of Micro-Armor 1000 per quart of lubrication.

Hydraulic Systems:
Add 2 oz. per gallon up to 5 gallons, then add 1 oz. per gallon thereafter.

Compressors:
Add 1 oz. per quart up to 5 gallons, then add 1 oz. per gallon thereafter.

NOTE - NOT TO BE USED IN AUTOMATIC TRANSMISSION OR OTHER SLIP OR WET CLUTCH APPLICATION